View source for Ultrasonic Ranger(Ping)(One Pin)

[[Image:TArduinoUltrasonicPing.png]]

== Summary ==
One-pin ultrasonic ranger module for distance measurement.  
Provides analog output for distance, digital timeout indicator, and ping trigger/echo control.  

== Description ==
The Ultrasonic Ranger (Ping) module measures distance using ultrasonic pulses.  
It uses a single pin for triggering and receiving echoes.  
The module can be enabled or disabled, and includes configurable pause time, ping time, timeout, and output units (cm, inches, or raw time).  
If no echo is detected within the timeout, the module outputs a predefined timeout value.  

<b>Diagram:</b>

[[Image:TArduinoUltrasonicPing.Preview.png]]

== Properties ==
*'''Enabled''' – Enables or disables the ultrasonic ranger.  
*'''Pause Time''' – Minimum pause time between measurements (ms).  
*'''Ping Time''' – Duration of ping pulse (µs).  
*'''Timeout''' – Maximum wait time for echo (ms).  
*'''Timeout Value''' – Value returned when a timeout occurs.  
*'''Units''' – Measurement units: rdCm, rdInch, rdTime.  

== Pins ==
=== Input Pins ===
*'''Clock''' – Clock input for measurement timing.  

=== Output Pins ===
*'''Out (analog)''' – Distance output as an analog value.  
*'''Timeout (digital)''' – Digital pin indicating timeout condition.  
*'''Ping (trigger)''' – Digital pin to trigger ultrasonic pulse.  
*'''Echo (digital)''' – Digital pin receiving echo response.  

== Categories ==
*[[Image:TArduinoSensorCategory.png]] [[Category Sensor]] – Sensor components.  
*[[Image:TArduinoAnalogCategory.png]] [[Category Analog]] – Analog output devices.  

[[Category:Components]]